It's a 94 GSR that I'm in the middle of putting into my 00 EX Coupe.
I'm having a mess of a time trying to fit the rear T bracket to where it needs to go. From the pic below you can (hopefully) see where the red arrows are pointing at the bolt holes, but the bracket itself seems too long to fit both bolt locations.
Does this bracket need to be swapped for the 99-00 B16 rear T bracket? I thought any B series T bracket would have been ok. Or do I need to swap out the rubber mount to the frame as well?
The motor also has a Skunk2 intake manifold on it. From the picture below you can see that there is a throttle cable bracket mounted to the throttle body. Unsure of what to do in order to attach my cable to the throttle body so that it operates properly. Should I use the existing mount? (Pic 2) or should I use the screw holes (pic 3) and fashion my own homemade bracket?
My only concern with this option is how to keep the cable from slipping out of the throttle body if its not coiled around it.
I'm having a mess of a time trying to fit the rear T bracket to where it needs to go. From the pic below you can (hopefully) see where the red arrows are pointing at the bolt holes, but the bracket itself seems too long to fit both bolt locations.
Does this bracket need to be swapped for the 99-00 B16 rear T bracket? I thought any B series T bracket would have been ok. Or do I need to swap out the rubber mount to the frame as well?
The motor also has a Skunk2 intake manifold on it. From the picture below you can see that there is a throttle cable bracket mounted to the throttle body. Unsure of what to do in order to attach my cable to the throttle body so that it operates properly. Should I use the existing mount? (Pic 2) or should I use the screw holes (pic 3) and fashion my own homemade bracket?
My only concern with this option is how to keep the cable from slipping out of the throttle body if its not coiled around it.