1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Please help me!!!!!!

Discussion in 'HYBRID -> ED-EF / DA' started by trancelucent712, Aug 5, 2005.

  1. trancelucent712

    trancelucent712 Junior Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Aug 4, 2005
    :( Ok i have a 89 civic Dx....i am in the middle of putting a D15a v-tec engine in it.....i was told that all i need to do the swap would be a wireing harness and ecu out of a 92-95 civic si and that everything would bolt and hook right up.......well as i went to change the ecu and i found that it doen't hook up to the new ecu.....what should i do about this???......also how do i use the new harness?? :( do i need to do sum re-wireing?


    Please please sum1 help me :worthy:
    any and all information would help me!!!!!!!!




    ethier post a reply or email me

    trancelucent712@hotmail.com
     
  2. evoracer03

    evoracer03 Senior Member

    Messages:
    113
    Likes Received:
    0
    Joined:
    Aug 22, 2003
    first off, are u sure its not a d15b? in any matter, the most painless way for you to do this swap properly is going to be by first doing the dp to mpfi conversion, then run your subharness for vtec wires, and run a obd0 pr3 or equivalent ecu. the are quite a few other ways to do this, but none that are much easier. all of the info you will need can be found by using the search function on this forum. good luck!!
     
Verification:
Draft saved Draft deleted

Share This Page