1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Question about Polyurathane Bushings?

Discussion in 'HYBRID -> EG-EK / DC' started by NeedACivic, Sep 8, 2003.

  1. NeedACivic

    NeedACivic Member

    Messages:
    80
    Likes Received:
    0
    Joined:
    Feb 23, 2003
    I just ordered the whole Energy Suspension Polyurathane Bushings kit for my 92 Civic CX Hatchback. My question is, Do i need a bearing/bushing press of some type to install them? Or can i push them in where they go by hand? Also on a 1 to 10 scale what would you rate this install, 10 being VERY hard. THANKS!!!!

    -Cody
     
  2. E_SolSi

    E_SolSi Member of the 20 nut club Moderator VIP

    Messages:
    30,036
    Likes Received:
    3,970
    Joined:
    Sep 28, 2002
    Location:
    CT
    they just push right into place ..... i wouldnt rate this any higher than a 3 as far as difficulty goes
     
Verification:
Draft saved Draft deleted

Share This Page