1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

rmoving chips

Discussion in 'ECU's, Electronics, and Tuning' started by efalex, Aug 22, 2009.

  1. efalex

    efalex New Member

    Messages:
    282
    Likes Received:
    3
    Joined:
    Sep 6, 2008
    Location:
    Danville NH
    i picked up a p28 from the junkyard the other day. i put it in my car with the jumperharness and it idles like shit. the idle surges and i have a cel. sooo then i tried a obd1 gsr computer and it started and ran fine. (NO i did not drive it on the ecu i know what would of happened :) boom. anywyas. i opend the p28 up and its fucken chipped alredy. my question is can i remove the chip, then have it re chipped?
     
  2. INJEN78

    INJEN78 HS LEGEND

    Messages:
    9,187
    Likes Received:
    121
    Joined:
    Oct 1, 2007
    Location:
    OHIO
    are you sure its chipped..and not just the oem chip??
    you can remove it and have it rechipped..when you do i would have a ZIF socket installed so you dont have to go through the process of desoldering and resoldering again
     
  3. japandrags

    japandrags New Member

    Messages:
    126
    Likes Received:
    1
    Joined:
    Jun 7, 2008
    Location:
    ca.
    or if you only want to run stock just cut the j1 jumper wire its located on the side of the 28 pin chip
     
Verification:
Draft saved Draft deleted

Share This Page