the new build 56k prob not a good idea

We may earn a small commission from affiliate links and paid advertisements. Terms

Status
Not open for further replies.
O

omega11855

Senior Member
well here is my dyno sheet on a stock bottomend unported head and here are a few pics of it being built so let me know what you think
s3fbc8ade15fb7.jpg

s3fc5669c1fbe4.jpg

Nice pistons
s3fc5667915fac.jpg

What compression u think that is?(lol)
 
nice, those pistons almost look like mine :) i dont' think they classify as stock though, lol
i say 12.5:1?
nice numbers too
 
Yeah that doesn't count as "stock bottom end." I'm guessing those pistons are in the mid 12s for compression. Nice dyno results!
 
no the dyno is before i built the bottom end im still workin on building it the dyno sheet is of
Stock type-r bottome end
s2s2 cams valvetrain
cam gears
edelbrock victor X
65 tb
rc 310
short ram intake
comptech race header
and exhaust
now i am building what do u think i will get out of my new mods
ctr n1 crank pulley
(p.s. no they arent balanced at the factory also what worry are harmonics if the full rotating assy is balanced clutch to pulley?)
probe rods(let me rev higher hehe)
12.8:1 pistons ib spec 81.5 bore
act 8.8 flywheel
eagle crank (not stroker but lt weight mine was bad spun bearing)
p&p the head
i think i have taken almost 25 lbs of the rotating assy.
so what do u think 20 more hp?
will be tuned with hondata like the last setup

hopefully by mid december it will be broken in and tuned again on the dyno
i cant wait lol
 
Holly "Shift" nice number.I hope with my set up I could get closed to those number. Damn it! I envy those numbers!
 
Bringing dead threads back for the sake of adding zero value comments is a bad thing. Please refrain from doing so in the future.

Thread locked to prevent further post whoring.

:locked:
 
Status
Not open for further replies.
Back
Top