tranny install problems on GSR motor

[fierceEG6]

Hi everyone

I have a B18c which i recently purchased and it came with a cable transmission. I purchased a GSR hydraulic tranny since my car uses a hydraulic tranny. The problem is cant get the tranny into the motor! We have tried several several times and it just wont go in.

Is the clutch different for cable and hydraulic trannys? ie clutch disc, pressure plate and fly wheel? do i need to change them all as well?

Any help would be appreciated. thank you

 

[y2kcivic]

check the splines on yur clutch disc , they may not match up... different years may mean different spline count !

 

[hoss95chev]

gsr trans won't go on engine

90-91 trans was smaller splines than 92 up

 

[qtmac_mien]

ya if it came with a cable tranny then u might want to get a clutch for a hydro then it should fit

 

[fierceEG6]

thanks everyone...engine is finally in the car..haha now the only problem is the wiring!!!

never again will i buy a swap that came out of a crx!