1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

tranny problem

Discussion in 'General Tech and Maintenance' started by dok, Oct 31, 2003.

  1. dok

    dok Senior Member

    Messages:
    728
    Likes Received:
    1
    Joined:
    Mar 20, 2003
    ok i gat a 92 hb with a b16a and a gsr tranny the problem is the clutch is about 7 months old it works ok but is taking a long time for vtec to kick in and it makes some noises when i let go of the clutch pedel and they go away when i step on it again. some one told me its the trow out bearing what do you guys think

    thanks
     
  2. dok

    dok Senior Member

    Messages:
    728
    Likes Received:
    1
    Joined:
    Mar 20, 2003
    i forgat if it is the clutch how hard is it to put on and what are pounds needed to screw in the screws and what brand and what stage will you guys go for

    thanks again
     
  3. dok

    dok Senior Member

    Messages:
    728
    Likes Received:
    1
    Joined:
    Mar 20, 2003
    come on guys
     
  4. HondaMoCo

    HondaMoCo Senior Member

    Messages:
    322
    Likes Received:
    0
    Joined:
    Jan 8, 2003
    Location:
    lancaster/palmdale So Cal
    you write like a retarted guy speaks
    the noise is more then likely your throw out bearing, the way to check if your clutch is slipping is roll about 10-15 miles an hour and then stick it in third and floor it, if it slowly boggs up your good, the rpms skip as its goin up its slippin.
     
Verification:
Draft saved Draft deleted

Share This Page