1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Will out of phase CV joints cause vibration?

Discussion in 'General Tech and Maintenance' started by 914turboford, Sep 22, 2004.

  1. 914turboford

    914turboford Junior Member

    Likes Received:
    Sep 1, 2004
    The left rear axle from my 1990 Civic 4x4 wagon appears to be causing the rear pumpkin to move about. There doesn't seem to be any play in the joints. I put a new boot on the outer joint and didn't pay any attention to aligining the inner and outer joints. Is it possible to get these joints out of phase? I assume this question would be the same as that for a front axle. I thought the term Constant Velocity meant there was no phasing required for these types of joints.

    Brian Roth
Draft saved Draft deleted

Share This Page