1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Will this dizzy work?

Discussion in 'ECU's, Electronics, and Tuning' started by 88SuperSi, Apr 30, 2010.

  1. 88SuperSi

    88SuperSi New Member

    Messages:
    5
    Likes Received:
    0
    Joined:
    Aug 9, 2009
    hey guys im getting ready to drop my brothers b16a2 engine and trans in my 88 crx si, my question is i know the b16a2 crank angle sensor is located at the oil pump and not the dizzy, im doing a obd1 conversion with this swap, am i going to need an obd 1 dizzy to make it work correctly? thanks.
     
  2. Magana559

    Magana559 The Warden

    Messages:
    2,568
    Likes Received:
    42
    Joined:
    Aug 9, 2008
    Location:
    fresno Ca
    you will need the dizzy to be the same OBD as your harness for it to plug in. you can use the OBD2 dizzy and just run a jumper from OBD2 to OBD1.

    You can leave the crank sensor unplugged on the oil pump if your running a OBD1 ecu because the dizzy already has one.
     
Verification:
Draft saved Draft deleted

Share This Page