1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

wut size bolts?

Discussion in 'General Tech and Maintenance' started by CRseX84, Jan 8, 2004.

  1. CRseX84

    CRseX84 Senior Member

    Messages:
    481
    Likes Received:
    0
    Joined:
    Sep 4, 2003
    Location:
    SUNY Canton College, NY.
    hey guys im goin down to get my new JDM siR and when i get back to my place i obvously am gona throw it up on a engine stand. i know u use the same thred size as the trans, bolts, but obvously a lot longer, but i dont have my motor here, can u guys tell me wut bolts to get for the engine stand? like the lenght and size and thread? thanks a lot guys.
    Tyler
     
  2. B16

    B16 Super Moderator VIP

    Messages:
    11,539
    Likes Received:
    534
    Joined:
    Sep 30, 2002
    Location:
    yay area, CA
    mine were 90mm in length
    depends on the stand you have too.
    i forget the thread pitch and size, do you have a helms handy? mines at home right now
     
  3. Captinb16

    Captinb16 Member

    Messages:
    84
    Likes Received:
    0
    Joined:
    Dec 4, 2003
    10x1.25 mm. Need about 6, just grab a handful at a hardware store or autoparts store. So a 4" will probably work for length. Make sure its fine thread and not coarse. You will know the differnce. Might have to measure about what lengh you need iam just guess about a 4" would be long enough.
     
Verification:
Draft saved Draft deleted

Share This Page