So I changed my axle last night. All fine and dandy, but I cant seem to get the ball joint pressed back into the lca! I tried lowering the car onto wood blocks, dropping it on wood blocks, hitting with a hammer, prying with an oversized pickle fork, etc. I cant get it to seat down nicely enough.
When I try to tighten it down the rod on the lbj spins with the nut not allowing tightening. Prying it down a little bit with the pickle fork worked for awhile but now ill be lucky if it gets 1/4 turn before it breaks free again.
Anyone have any other ideas?
When I try to tighten it down the rod on the lbj spins with the nut not allowing tightening. Prying it down a little bit with the pickle fork worked for awhile but now ill be lucky if it gets 1/4 turn before it breaks free again.
Anyone have any other ideas?