To anyone who wants to earn some $ by helping with completing a swap for a buddy of mine? Located in Richmond,Va. Engine is in, just needs to be wired and pretty much started.
b18c5 into a 96 civic cx. Turn the key and the car turns but doesn't start unless throttle is open. When the throttle is released the car dies. Can anyone tell me what could be the problem?
98 usdm itr ecu. I found a plug which is located in front of the drivers side front bumper. Seems like all I have to do is extend those wires and splice it? I also tried to start the car and it only runs when I open up the throttle. After I let it down the car dies. Do you know what could be the...
I have a 96 civic cx and the catalytic convertor i'm putting in for my swap has a secondary O2 sensor. Trying to find out where the damn connector is for it. The originial motor doesn't have a secondary O2 sensor....i believe, just the primary sensor.I looked underneath the car of course and I...
oh yeah, i forgot to ask, which wiring harness do I use? motor came with its wiring harness and i also have the wiring harness from the cx motor. The plugs from the c5 does not plug up to the plugs from the car. Anyone located in Va or would travel to Va?
would it actually be easier if i get a 99-00 ex harness and use the 00 itr ecu? I heard that you couldn't use the 00 itr ecu b/c of the immbolizer, is that true? What is a clip?
okay, so buy a 96-98 ex harness and buy a chipped p28 to itr spec ecu? Would I also have to buy a obd2a-obd1 conversion harness? If I reuse my cx harness what wires would i need to add and how do i add them?Sorry to ask all these questions, I'm clueless about this part of a swap.
I have a 00' b18c5 thats going into a 96 ek cx. Which wiring harness do I need? I have the wiring harness from the b18c5 and also from the d-series. The driver side wiring plugs (comes from under the dash board through the firewall) doesn't match up with the c5 except for one plug.Also, would I...
Waiting for my energy suspension motor mount inserts to come in then I'm sure I'll have more questions. I should get them next week, and depending on where the hurricane is going to hit also may delay my swap. Thanks for the help so far though.
what about all the mounts, I wasn't able to find any studs or rubbers. The swap already includes a 00' si rear mount and all the brackets. What are the remaining mounts and studs and rubbers would I need?
I'm putting a 00' b18c5 into a 96 ek and I've heard that since I'm using the itr's ecu I would also need to use the key from the itr and switch the ignition system. Also, trying to get some energy suspension motor inserts. Does anyone know if I buy the inserts for the car or engine? What motor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.