Im getting all kinds of codes im going to find them out, i dont think my ecu is in limp mode, my car does not idle at 1k rpm like It should, it idles at redline or at 3k rpm, does that make enough sense?
sorry,
i just finished this swap
couldn't get it to start, changed the main relay and gave it some starting fluid and started right up
i burned off all the starting fluid and starts now
it will idle(1k) for a few seconds and then goes from 1k to 3k rpm in a second
i switched the tps wires around...
Got my motor to start after a very long mpfi swap, i switched the two wires at the tps and the motor then goes the redline around 3k rpms. need any knowledgeable help as soon as possible thanks!
where do the lines go?
does this substitute a new place for the oil filter or no? bcuz the oil filter is impossible to get to an i was thinking of relocating mine to make oil changes easier.
if any1 is familiar with the tokico hp suspesion kit or jus lowering kits in general, i need to know:
-If the kits r specifically made for a specific drop rate [front, rear] will the suspension/ chassis have the common inward flex?
-If so what sort of camber kits would i need to get or any...
im looking into dropping a d16 into my 91 base model hatch, ive been told its a direct drop in an different wiring is required, what wiring would i need to get? and if anyone recomends a jdm place i can get one from in los angeles area, any feedback would b great.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.