Recent content by CRXcamaro

My car is suppose to be a 90 CRX Si. How do I tell the differance? My gauges worked, but I didnt want KPH that were in there. I swapped in a set of guages from another CRX and NO gauges work except engine temp, and the high beams turn the seat belt indicator on the guages off and on. Is...

As stupid as it sounds, where is my MAP sensor? The car has an Ecu with the writing '91 Integra 5spd written on it. Were any of these cars mass air flow?

I have a 90 CRX Si with B16 swap. I bought it blown and rebuilt it. It has only one 02 sensor in the mid pipe. The engine cannot find idle, it goes up and down. Normal driving it runs well, should I have two 02's? Or do I have another problem? If I do infact need two sensors, where do I...

thanks for the help! what about the second fan, does it come on only with ac?

Sorry for jumping on your post, but I have a ismilar problem and didnt want to start a new thread. I was wondering, I bought a 91 CRX Si, it has a B16a swap. The disributor has the ears broken off. So is it a D16 distributor? For a daily driver would I be better off getting a B16 unit? How...

I think mine is acting up too, is there coolant running thru IACs? Or does it work off of vacumn?

Wow I will need to start a new thread. I am lost, and since I swapped the new short block into my car, it wont run right at all. I am confused though because it ran great for the guy I got it from until he threw 2 rods.

2nd o2 sensor? Mine only has one o2 in the mid pipe. I have a header maybe thats why. It seems to run well though...

Well, I was thinking about an aftermarket underdrive crank pulley anyways so hopefully it has the timing mark. I'll give all that a try, thanks alot for your help..

I bought a 91 CRX Si that already has a B16 swap and there was no denting to get the alternator to clear. I have a B16A with a cable clutch 5spd and I the only things I can see are the swap mounts, the resistor box for the injectors, and very lightly moding of the wiring harness. Of course it...

My CRX with a B16A swap threw rod, and knocked a huge hole in it. Used another B16A block I got from EBAY. It is identical except I could not use the oil cooler. No big, but it turns out the cooling fan switch that mounts in the block near the oil filter doesnt fit. There is a hole but it is...

There isnt a mark on the stock pulley, so is it the same if I pull a spark plug and use a screwdirver on top of the #1 piston to find its highest point, then point on the cams gears up? Also, I dont have a timing pointer, so how do I tell what the timing is set at? Thanks

So, after it is started, yes it is currently retarded all the way on the distributor, and it runs but not right, reset the timing again by finding TDC, then settup the cams again? Will this center my distributor giving me more room for retard/advance?

Come one guys, I know somebody out there can help me?!

I have a 91 CRX with B16A conversion. Everything worked fine until it threw a rod, I had the short block and head rebuilt and I reinstalled it. I have fuel, and I have spark. I thought I set the timing right. Maybe I didnt. How do I set the timing on an dual overhead cam car?