Recent content by hatchhonda19

im looking for a MAP sensor for my 1991 civic...

if you car is OBD-1 upgrade the motor to OBD-1 all you will need is a dizzy i dont remember what year OBD-1 dizzy fits the DOHC ZC but im sure if you look around you can find it. just remember to get a NONVtec dizzy, the P28 ECU you have in you car.. will run the ZC fine. i you want it to get...

yea....it should it just maybe had to see.

i have the resistor box.. $40 thats $5 less then what i paid for it... and if you want pics i can take them.. i also have the male end that plugs into it... so if you doing a DPFI to MPFI you will be set.

just take the blue not the black the black is a ground.connect that to the wire that goes to the vtec solenoid it should be green. and there you go. you pressure switch is disabled,

vtec will not open when the CYP Sensor is bad right? the only CEl i have is a 9.. 9=CYP Sensor (Cylinder) defective circuit or unplugged / defective sensor

if you look in the middle between the header .it will have a date on it. 89-90-91 somthing like that that will tell you what year it is

i got a 7 pound in my civic wiht a D16z6 motor. with a stage 3. 6 puck its hard to drive around town or in traffic but ones you get some heat into it it grabs really good. and i raps up really quick you know no weight holding it back. i like it it just hard to get use to. you can also feel the...

i just PMed you back... im your putting OBD-1 motor in OBD-0 car??? cuz thats what i did.. and i did the wiring myself really easy..get this converter harness.Honda/Acura OBD0 to OBD1 Conversion Harnesses get the DPFI to MPFI one its $20-30 more but it makes the swap really easy... it got my car...

im looking to a D series 1990-1991 si trans. in the long island area. my trans just took a shit. someone please help me out.

i have one my me a offer.

yea is there a rebuild kit for the distributor? cuz the Distributor i have i have OBD-0 connectors on it

Horsepower Design Equations Formulas Calculator - Power Weight Ratio

ok i checked it, i have 4 short 2 long and i have one short after the 2 long then a brake. tehn it repeaters

Ok i have a 1992 d16z6 motor in my 1991 civic....the rpms will not go passed like 3000rpms.. when i hold it wide open it sounds like its hitting the rev limter.i think i have my firing order off or my injecters.. does anyone know anything i dont know.if you hit it wide open the brign it down a...