I checked all the connection, sensors, and vacuum lines and everything is correct. Just afew minutes ago I took out the top bolt on the fuel filter and trie to put in a fuel pressure gauge but the threading was different. I drove it to the store and when I came out it wouldn't start and it...
gotta figure this out cause ive got a ram horn turbo kit on the way and already have the 550 injectors. It works for a B-series so if all else fails.... Found a 94 ex sedan with blown head gasket for 800 and actually considering getting it so i can side by side part swap.
getting closer
Tried another z6 dizzy and same thing it will rev to redline sitting still with just a burp. Driving down the road it won't flat out accelllerate and you have to wean the throttle past about 3500 to 5000 rpms. Any Ideas? Still no CEL
found most of the problem
Got the car to rev sitting still. The distributor was apparanetly bad maybe the CPS or something. I stuck a D15 non vtec on it even though it wouldnt bolt up and it fired and revves great. Took the insides out and transfered it to my dist housing. Now it just has a...
no change just louder!
I put straightpipe all the way back to a resonator with a baffle. I had it from NOPI about 7 years ago still in the box. Loud as hell but no change. I guess it could only be the distributer then.....or my ecu has went bad!?!? im sick of part hanging. if im gonna kep...
probably will so I'll know faster but I have a new header to put on it so I might just hang it and not connect the cat and cross my fingers. I decided to start it and get it warm to melt out any ice that might be in the system so I could drain it and put in antifreeze bc it's down to 12 degrees...
what would cause my fuel pressure to be 80psi? I've took off the adj regulator and tried oem regulators but nothing will decrease the pressure. I think the problem might be too much fuel. It idles perfect but any gas and it boggs so that's the only thing left that it could be.
I converted to a 5speed while I was at it. Where it was wrecked I had a TPS code because it got smashed and an o2 sensor code same reason. Replaced the 3hrottlebody off of a running 95 z6 and no codes. I have sprayed ether around the engine(while cold of course) and I couldn't find any intake...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.