B, D and H series parts - B series into an EF/ED shift linkage, Brand new Luk clutch
(3) RB20DET Side mount intercooler $20 Ea
H22a Alternator $30
h22a P/S pump $60
H22a engine harness (JDM uncut)
88-91 CIVIC
pr3 chip (knock/speed limit disabled/stock fuel/ignition maps) $20
D-mounts w/Energy...
There is an obd2 d15b 3 stage VTEC. Anyways to try to fill you in on your d15b and a couple other things. All sohc 1.5 blocks have a deck hight of 207 mm. All sohc 1.6 blocks have a deck hight of 212 mm. All 1.5 connecting rods have a length of 134 mm EXCEPT the JDM d15b and USDM d15z1, they are...
you want a deviation of less than 10% from cylinder to cylinder. Pull your A/C compressor and condensor and P/S pump. Then strip everything behind the rear seats, but if thats not for you and you just want easy horsepower gains then go spray it.
I have a set of kyb struts w/Neuspeed springs off a DA laying around. Just wondering if they are compatible with an EG. I believe I will need DA forks correct?
b18a1 shortblock - needs to be bored over
d16z6 shortblock - spun bearing, needs to be bored over
del Sol driver side headlight w/o corner
EG B series motor mounts - great condition
HF manifold
Garrett turbo - pulled from a friends eg coupe, has shaft play, crappy downpipe came with it...
Make offers, the stuff is just laying around
Ls cable tranny (no grinds)
D16z6 block (spun rod bearing)
B18a1 block (needs to be bored over)
D16y8 head (rocker arm ass. and cam included)
JVT 4-2-1 D-series header brand new
B18a1 4-2-1 header
d16a6 intake manifold with fuel rail and...
My friends mom spun a rod bearing in her manual EK coupe it had a d16z6 block/y8 head combo (they bought the car like that and didnt know untill I told them) anyways I found a d16y7 for cheap w/ low miles so I used that with their 99-00 manual y8 intake manifold and y8 exhaust manifold. The...
Do the holes have to be plugged? I'm doing the same swap but I got a 99-00 IM gasket and it isolates all 5 holes. If I use that gasket can I plug the hose comming out of the top of the manifold flange to block the leak?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.