Recent content by muzeii

bumping this as i'm still stuck. -tested alternator, its fine -replaced fuel injectors -replaced clogged PCV valve -cleaned and checked all sensors on throttle body -can't find any vacuum leaks -replaced fuel filter next thing i'm thinking is the o2 sensor? I'm really running out of things to...

did you ever figure out the problem? I'm having a similar one. any info on success would be great!

Car: EG with JDM b18c typer swap Just started happening the other day. I drove to work in heavy rain, then when i went to leave work my car was idling really funny and when i got on the road i had horrible throttle response and my car struggles to accelerate. I had a problem with my dizzy...

I had a very similar problem with my swap. I checked everything and NEW everything was setup proper, power to injectors, dizzy, timing (as close as i could with out starting it), it would crank, etc but no fuel in the cylinders (pulled plugs to check for any fuel smell after cranking) and the...

are you putting it into an eg of ek? you mentioned both and it makes a big difference...

engine was used... i assume they were broken in properly. It originated from Hmotors with 32k on it ran in a freinds car for about another 25k, ran fine until he messed up the valve guides on the exhaust side (over revving pretty sure and floated a valve). I took the motor had the head rebuilt...

umm you can see all the way through it, its bubbled out a bit with some sort of stuff inside along the walls in the bubbled out area... kinda looks like those "cherry bomb" mufflers u see on old muscle and trucks... some ebay shit my friend had in the garage. yeah i'll have a look tomorrow. I...

hmmm yeah, i just don't like it, it shouldn't be doing that. I guess when i get a better look at the smoke i'll know more. I'm also running a high flow cat...basically a straight pipe, wonder if that effects it much.

Yes it's connected to the tps sensor. I have one. I use it to set my vtec point. I have it cause it was there for me to use when i did my swap. I don't know enough to use it's advanced features so i don't mess with them, but i know they can be used fairly affectively if tuned correctly. I find...

I run Mobile1 full synthetic in my jdm b18c... I dunno personally with high rpm motors i feel synthetic is a good way to go, but expensive. In the grand scheme of things though it probably doesn't matter much as long as you change it regularly. I'm sure people will argue it to death though as...

So I hit a glitch in my project today....and i'm concerned and i think i know what the problem is, i just don't want to face the music yet...so i'm hoping someone on here can give me a couple ideas as to what else the problem might be. A few of my friends have said they see smoke come out of...

still having problems? I did a b18c swap and accomplished quite a bit of troubleshooting myself... umm there is a list some where on this web site which will tell you what the codes mean so you can start checking from there. It could be a problem with one thing or sensor or whatever... and...

Hello all, I've been posting on and off for awhile, current condition: running my JDM b18c swap in an eg with a chipped p28. She's been running fine off the basic chip that's in the ecu, but now that i've rounded out some other concerns around the car and everything is solid, I'm turning back...

Well I stated this project back in may of this year, and by the end of june i passed state patrol inspection. Since then i havn't had much time to work on the car or post on here! I figure a picture post of my project is way past due. It's winter break and I have time to put in some hours on...

I just finished wiring a switch and power to my pump, i can turn it on and get pressure at my fuel rail now, i tried starting the car nothing new. It does try to crank but just doesn't start. I just looked down at my vtec controller and noticed that it does not register when i push the gas...