Recent content by Schock3

Ok. I have a 1990 crx Si w/b16a have been installing a rev hard turbo kit and it is finally competed and sitting. I have bought 450cc injectors and a p28 basemapped for turbo and converted to obd1 with a rywire harness. I have also purchased a TD-44U Dizzy. when i got done the car started. when...

I just bought some LOW IMPEDANCE 450cc injectors and im doing the OBD0 to OBD1 conversion. do i use the resistor box that is already in there?

just gunna say the same shit. u def have a popped fuse or a ground is off

yesss forgot about that little bugger!

plug it into ur tranny and then to the back of ur cluster and u should be good.

the speed cable teeth might be fucked up in the trans. take it out and look

take it out and soak the cable in wd-40 or some kind of lubricant for about 20 mins u should be good after that.

i am sending out the ecu to be chipped and tuned to my mods

anyone heard of Speed Innovations?? you send your ecu to them and they chip it for you. SPEEDINNOVATIONS.COM - Technologically Advanced Performance Solutions. you also tell them all of your mods. just wondering if its any good??

b16a. i have no idea how long these injectors have been in.

also a oversized intake manifold

should i go with OEM injectors?? or should i get slightly bigger ones. i have a oversized throttle body, racing headers, straight back exhaust, intake. i intend on upgrading the whole fuel system. what do you guys think?

Anyone know where i can find ecu wiring diagrams. i have a 90 siR and have to add in a o2 sensor. already found the o2 simulator thanks fellas

with one should i run?? on my exhaust the outlet where the o2 screws into is before the cat not after it

do you know what wire i should be lookin for off the ecu?? i have 2 wires that dont go to anything. this car has passed emission's and everything.