Recent content by sinfulcivic

what is the helms?

helms?? what dat is?

it is only the gauge lights that stay on, and not every time??? weird, but thanks. I must have something so obvious thats wrong, i cant see it....... I have the big Chiltons repair manual, and the little Haynes, but i cant seem to get the same answer from either one about the exact pin locations...

thank you for the info on the E.L.D. location, I did some un-wiring of the injectors and am getting a code 16 and a 20 now. I also checked the voltage to my injectors while running and am getting an erratic voltage difference, both between injectors and each single one. The exhaust is black, and...

sorry, had my kid try to type for me, Im getting a code 20 from the ecu, but i dont have a test harness. 20 is an electrical load detector. dont really know where to start.......It is running good other than the fuel overdose.? i dont have a clue what it could be?? any help?

ya i am, 20 eld. Where should i start :blink:

Swapped for a D16A6, along with a PM-6 ECU, did my best on all the wiring mods, put it in a Civic Hatchback,1991 with 5 speed. Got her running, actually seems to run ok, considering that its running soooooo rich that gas is actually coming out the back of the exhaust and dripping from the...

thanks, i'll try it

exactly right!! i have been trying to make the pm5 work for me, and did get it running, terrible, haha and had to break down and get a pm6 from an si, just fired her up this am. need to tune her a little , runs kinda rough still, but do i need both wires, (yellow w/black) running to resistor...

I have a 1991 Civic Std Hatchback that had a D15B1, (or so it is stamped) that i swapped for a D16A6 out of a 1990 CRX SI. My question is can i use the Ecu that i have, a pm5, the control the new engine, the old eng. had a four speed tranny, i have a five speed now, i dont have the pm 6 ecu...

Anyone have any experience with A D15B to a D16A6 Swap, and a DPFI to MPFI at the same time? I almost pulled it off, but the car is stumbling and runs so rich that its fouling out the spark plugs. I am using the ECU from the Civic which had DPFI, as i was informed i could with the mods to the...

never mind, i figured it out anyways, thx

:D Hey, Im looking for the exact pin locations on an OBD0 myself.....in specific, for a dpfi. I need them to do this conv. to a mpfi, can you kick me a link, preciate it.!! B)

OK, the beginning, i did a swap out from a d15b1 to a d16a6 and needed some assistance with the dpfi conv. to mpfi. I have completed everything necessary except moving the wires from ecu pin c-1 to b-10, and c-2 to b-12, then hooking up the blue w/green and the blue w/yellow to c-1 and c-2.. I...

ok, is there anybody that can produce a diagram, or actual pin assignment for my ecu? I have a 91 civic hatchback, and have almost completed the dpfi conver. over to mpfi, but i need to find ecu pin B10, and B12. I am supposed to change the wires from c-1 to b10, and c-2 to b-12, but b10 and...