Recent content by spydy43

+1 About the only thing you can do to check and see if the radiator is flowing is by getting a temperature gun and checking to see what the temp is on different areas of the radiator and the hoses going in and out or the radiator.

Location : Albuqurque NM What is your email address and I will email you some pics? What are you interested in?

Doesn't a FMU constantly over pressure the injectors when you are in boost? All I know is shortly after boosting with the FMU in my car the car would bog at low RPMs or when I hit the throttle and I could smell excess fuel because of the injectors leaking.

Try a leak down test and if you are losing pressure listen to where it is coming from that should tell you where you are losing compression.

bump...

where are you located, 2 door or 4 door, and do you have the front passenger seat, sunvisors, and sunroof visor?

FMU can cause your injectors to leak whick makes your car bog down cause its too rich.

What kind of tuner would peak the boost that high on a stock block? :blink:

bump...

Well I have been thinking about selling my project car and want to gauge interest. I just dont have the time or the patience for it anymore. The motor has been in peices for 10 months now waiting for different things to be done to it here and there and I just dont know if I want to wait any...

Thanks for the input, but does anyone have any ideas on what they would sell or buy a car like this for?

This guy near were I live is selling a 97 civic cx. It has a b18c5 swap around 60,000 mi estimate (has new timing belt, water pump), I/H/E, nuespeed springs, koni adjustable shocks, gsr interior... and a whole lot more. The exterior is clean and near stock other than the rota wheels that he...

Are those out of a two door? Are you willing to ship?

I have a d16y8 my daily driver that I put about $4000 into for rods, pistons, hg, arp studs, turbo kit, and tuning. Dynoed at 230whp 200ftq at 10psi. I have recently had the block sleeved and I am now in the process of having it rebuilt to see what I can get out of it. For me the D was the...

I have a motor d16y8 motor that I need to have built up. I dont have the time to do it myself. Does anyone know of any engine builders in the southwest(arizona, colorado, west texas) that will do the job right the first time.