Recent content by Uppertorso

I purchased a D16z6 and it had an S20 transmission with it. Is it the equivalent to the D16y8 transmission in USDM??? It revs at 3000 rpm at 60 mph if that helps, thanks in advance AP

The computer we are using is from a running integra 1993. I will try to get some pictures of the ecu for you guys, but not till monday, we are closed for the weekend. I have heard from another source that maybe we should be using a p74, instead of a p75. Thanks guys

I hate to break the news to you, i work at a Honda dealership, I think we know how to read the codes. But we ensured that the ecu was a P75, we even took it apart to see if it was tampered with, and it is a virgin ecu (not modified for uberdata). Maybe we are missing something..... Anyways...

I shit you not, these are the acutal codes, anyone have similar experience or input?? AP

I have a 95 civic 4 door, with a B18 installed in it. There is a P75 ecu throwing code 22 and 21. These are VTEC codes!!??!!?? This is a non-vtec ecu. Has anyone encountered this before??? We have checked the wiring, all is ok. The vehicle also has a hesitation problem between 1000-2000...

Yes it will, that is an OBD2 vtec alternator.

D16y8 timing belt part number : 14400-P2F-A01 D16y7 timing belt part number : 14400-P2F-A01 they are the same. :) Happy Hunting

Your map sensor will not prevent cranking, you should be looking at your starter circuit. Do you have any power when you put the key in the run position (lights or dash lights??) If you don't your battery is suspect. If you do have power I would start by jumping your solenoid to see if the...

Check the adjustment on your throttle cable, it is the cable that goes from your gas pedal to the throttle body. If it is too tight your idle will be high, as if you have your foot on the gas. ;)

http://cgi.ebay.com/ebaymotors/ws/eBayISAP...&category=33596 This might make your life easier. Conversion harness does all the thinking for you. ;)

https://hondaswap.com/forums/index.php?showtopic=29360 Check out this link (it is in the reference section of good ole Hondaswap.com), i am uncertain what car your B16 SIRII is coming from, but if they are both OBD2a you are laughing (plug and play with ecu, just add the missing wires to your...

NO PROB, ANY TIME :)

DOH!! :doh: Maybe i should read a little closer, anywho, i hope that info helped. :gmorning:

http://www.superhonda.com/forum/showthread.php?t=212713 Check out this thread, it is the best write up i have seen for swapping over the D16Y8 intake onto a D16Y7 I think the automatic intakes have the IAC as part of the throttle body, but on the standard transmission intakes they are located...

THANKS :D