I just did a swap in my 90 accord and what i did was used the p/c bracket that came with my original f22 accord motor and used my orignal p/s pump. What you do have to do is cut a piece of metal tubing or use nuts to shim behind the hole on the bracket. The reason for that is there is a small...
Yes the ecu is obd1 Also i did not use a jumper harness i just pinned the ecu for the vtec. Tab got the diagrams for me on which ones to pin. Pretty sure i have it right. Does the vtec oil pressure switch always feed a positive signal or negative??
I recently did a swap on a 90 honda accord with a h22a vtec engine. Car runs great except the vtec is not engaging. From the wiring diagrams i got off hear it's pretty sure i have them pinned right to the ecu. What i'm getting is a constant ground from all three sensors even when the vtec is...
I have an automatic too and i tried doing what you said and it works pretty well. I compared it to my 92 prelude that has the same motor and noticed little difference. Advancing the timing seems to make up for the low end torque. Maybe down the road if i come across one i'll stick it in...
Yeah i will get the picture to you tomorrow TAB, i have to load it up. I wanted to ask you a quick question though. When my engine arrived the IAB was broken. I did not wire it up and eliminate dit completely. The car runs fine and the vtec is working as well. It also did not set a check...
hey TAB it still will not let me view the pics on the hondaswap website. Can you please just send a brief description of what needs to be done with each of the pictures. Also from what i understand i only have to run 4 wires to the ecu correct? Knock sensor, Vtec solenoid, Vtec oil pressure...
TAB i can't get the damn pictures to load up now. Can you send them to my email for me. khs128@psu.edu. Thanks and i'll telly uo what i think, but i'm sure there good to go.
Thanks TAB i will get ont he picture probably tomorrow for ya. Yeah this is my third one too and it just makes it so easier when i can get the pics from someone instead of tracing wiring diagrams out on mitchel on demand. I do that crap all day long and i just like it when things are easy for...
Yes this message is for TAB. Last time TAB i sent a message for some wiring help with my 92 honda prelude. You came throught with telling me which pins i needed to tap into at the ecu wiring harness and and also included some pics which was very very helpful and i thank u. Now i need some...
Hey TAB i have one more question for you. When i did this swap i used the h23a auto tranny. The swap i bought came with a auto jdm tranny, but i did not use it because i knew mine was good and i didn't want to get shot in the foot. What i want to know is if i switch tranny ecu's will it...
Yeah it wasn't bad at all. I have done three swaps prior and the last one i did was a gsr motor into a 91 civic si. It was a nightmare, but i got it done. I promised myself i would never do one again so i was leary about doing this prelude, but it was simply. The only hard part (not for me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.