Just did my swap and everything went pretty smooth. when I was transfering over the eng harness the speed sensor pigtail did not clip into the b16 vss. I popped the wire pins and tried putting them into the old clip. They went in but I dont know if the went in properly because I have no...
hey I have a 93 del sol and the wiper motor locked up. I dont want to buy a
new one because I'm saving my $$$ for another project. If I go to a junk yard
which motor will fit this application.
well I just finished my swap a sir-2 in a 95 ex. I was driving it for a couple of days when I noticed a clank clank noise from somewhere. it was not a patterned noise it was spuratic like somthing was moving around. it would do it at idle when I pushed the clutch in it would go away.
it got...
Sup peeps, just put a sir-2 in a 95 ex and went to fire it up and it started right up
when you give it gas it boggs like it wants to die. If you manual turn the throttle slowly it will rev up but start banging out at about 4 to 5k-not all the time though
it does have a cel but I have not run...
I have a 95 ex that I'm dropping a sir 2- the b16 p/s line going to the rack was cut
right after the sensor- can I use the line of the d16? and will it bolt on to the b16a
pump? let me know
I have a 95 ex coupe with a d16z6. I have a sir-2 I am about to drop in. the motor came from japan so all hoses where cut. My question is will the heater core lines that are on my ex fit the b16a. What about radiator hoses? How well would my stock radiator perform? let me know!! swapping in a...
I just purchased a jdm b16a sir-2 and before I drop it in my car I am going to replace timing belt and water pump. I to the honda dealer and the part#'s where different for delsol dohc and 00-si waterpump. Is it the same part? Which one do I need? somebody let me know.
I am planning my swap(jdm b16a sir-2 in a 95 ex coupe) and I realized that the motor I was getting was out of a 92. Correct me if I am wrong but they still used r12 until 93. My question is can these a/c compressor be used with either type of freon or should I plan on getting a newer...
I have a 95 ex coupe and I am dropping a jdm b16a2.
is the only thing I need to wire up extra is the knock sensor.
the swap came with the harness but it is cut. should I just use my stock harness
and wire up knock sensor. or attempt to install and splice together new harness?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.