Search results for query: *

Im selling this OBX Turbo Manifold ITS BRAND NEW it retail $575.00 MRSP CHECK FOR YOUR SELF : http://www.obxracingsports.com/performance...D=3&subcatID=21 . I bought it for my setup but i have a 35mm wastegate and this manifold is 40mm .It is BRAND NEW NEVER USED PERFECT CONDITION .........Im...

I want to put some rear disc on my 90 civic SI hb if it possible and if so what part do i need from what car.....A PART LIST WOULD GREATLY BE APRECIATED :blink: :unsure:

OK all was fine i went to work and i worked sorta LOL so im bored i start cleaning my engine polish here and there so i stuck my hand behind her intake manifold near the oil filter cuz the stupid main harnness barely reaches the knock sensor and the other 2 sensors and i tried to pulling it a...

Ok im confused again,wich resistor do i need to run for the blue DSM 450cc injectors on my 90 civic turbo setup.Can i still use my stock one or will i need to make some modifications B)

My car has been smoking a bit white blue and it smells like raw gas everytime it gets warmed up and in the begining to accelerate?? how do i fix this problem it has new ARIAS PISTONS 81.41 this dude makes them at 81.41 instead of 81.50mm ARIAS SHOP new rings and all 9.1 compression for my turbo...

I have my old swap out of my 90 civic hatchback SI .I live in LOS ANGELES if any body has a B18A1 calbe tranny i will trade the whole engine for the in good working order no grinds tranny also have the ECU shift linkage wich i will include engine is still going hard trust me. EMAIL ME AT...

OK i bought a walbro 255lph part # gss342 is this the right one anyw00t i was about to install the damn thingy and to my surprise it isnt under my rear seat all i found was the GAS FLOTER in the middle of the rear seat and fuel lines next to the GAS FEED PIPE (where you fill the tank with gas)...

OK i have a used Factory LSD Y1 tranny on B16 and i was using MOTUL 300 synthetic oil for about 5months and i still have a bit of grinding on 2nd gear...so i take my engine apart for rebuild for turbo and i drop all KInds of tranny oil everywhere,So now the engine is back on and im looking for a...

I need to know wich turbo head gasket to use on my set up,what kind of material im not going to push alot something safe like 30psi......LOL no no just around 7psi to maximum 14psi no more ,I only bored it .20 over from stock ?will i need the head gasket to measure 81.50mm and if so where do i...

How do i make these DSM 450cc injectors work on my 90 civic Hb with a firs gen B16,What will i need to do to the PR3 ECU,i was looking at this link where it says all you need is a SAFC or The VAFC http://www.thedropshop.tv/vafc.htm i listed my mods in the SIGNATURE if it helps...