Search results for query: *

I dont think there is a way to use just the Si harness you would have to change the harness that goes from inside the car to the engine compartment. To save you a headache go to the junk yard and pick up another dx harness you will also need an injector resistor box. I have done two of these...

Got it Fixed!!!!! There was a bad wire and ground under the dash.

still need help I replaced the altenator and the battery but still have an issue car fire ups and idles fine but as soon as i turn the lights on it will draw power from the battery and cause the car to die I am able to drive the car but while i drive it acts up if i use the ac signal lights it...

I have a 91 da and the car will start but if i turn the lights or ac on it dies. Also my gas gauge does not work and the temp gauge goes straight to hot. If i turn the signal lights on it makes the temp gauge bounce back and forth also. If i drive it the speedometer goes back and forth and does...

I found one locally just thought id let you know

will you take 80$ how much to ship to 76106 im sure the answer is yes but is it in full working order

has the pr3 been chipped

how much to ship to 76106 do yo have a pic do you know if its a auto or manual let me know i have been looking for one and cant find one

Block sold already sorry guys

I have complete b16a bottom end it has all the internals still intact was going to piece together a swap but bought a full B16a swap instead asking 300$ or BEST OFFER will trade for a PR3 OBDO ECU and some cash email me for pics i can ship if needed but its heavy and might be pricey

Just got a hold of a jdm b16a swap as for as parts like misc. gaskets, spark plugs,wires,timming belt, etc etc etc Should i ask for parts for a 92-95 Del sol si w/b16a or 92-93 Gsr B17a1 also its i bought it from a guy who bought it from Nippon motors should i replace the head gasket also or...

how much for pr4 obdo ecu shipped to 76106

Just got a 91 teg and the ecu is throwing a code Flasssssssssh then flash flash flash im guessing that is a code 13 Atmospheric Pressure Sensor - Defective circuit or unplugged/ Defective sensor where is that located also it idles at 3000-4000 rpm's any body have some info on this

Will 94 integra seats work in a 1990 hatch?

here is a update my ground cable was loose i forgot to tighten the bolt back down when i replaced my clutch.

sorry i meant like a relay click not a starter click the starter doesnt click at all. I removed the starter and had it tested and it passed. When the car is running i turn the ignition to start the car again whike its running and the starter will engage and you can hear it grind so i know its...

I pushed started my car and drove it for ten minutes then parked it. I went to start it again and it worked. I didnt think it was the starter cause the starter didnt click at all. Should i still remove the starter and have it tested could it have been stuck. While my car was running i made...

I have a 90 civic hatch i drove it earlier and it started up fine. When i went to drive it again a hour later it wont start. It doesnt even crank over I put the key in the ignition and go to start it and it does nothing. I checked the battery and it has plenty of power lights turn on and radio...

I replaced my clutch today and when I removed the old one I found a piece of metal that broke off the clutch. It tore the clutch up and was floating around. Your were exactly right just thought i would let you know thanks again.

It should work with no problem I had one on a d16y8 head when i had my crx.