Search results for query: *

If it is, it will have "LSD" written using paint on the top side.

Nice.

What engine harness/ECU are you using?

How do you know that it is not kicking in?

When you installed the cable reel, did you make sure to turn it clockwise until it stops and then counter clockwise approx. 2.5 turns so that the arrow is facing straight up. Also does the cruise control work now or..

At the minimum you need the head gasket, intake manifold gasket, and the exhaust manifold gasket. You should only get the others if you are planning to take apart the entire head while you are at it. As for the head bolts the Service Manual doesn't say you need to replace them, but majestic is...

Is it throwing any codes besides the ones for the missing auto tranny?

I spent one weekend in Boston, MA for Anime Boston in April and another weekend in Sommerset, NJ in June for Anime Next. Both were good, but I basically attended them to go shopping.

Could always just take it off before each event.

You could press in the 5-lug hubs on the front because the bearings are the same, but I am pretty sure that the 5-lug rotors would be too big for 4-lug calipers. As for the rears the bearings are bigger than what you currently have, so you would need the 5-lug trailing arms and since it will be...

Probably cable reel related. It sits in between the steering wheel and the steering column and has the wiring for the SRS airbag, cruise control switch, and the horn.

Looks nice.

Tried to register, but it said page not found :(

If it's the primary O2 then probably because that is what the ECU uses to change the AFR and it can't lean it out the way the HX is designed to if the sensor is bad.

Replace the cap and rotor while you're at it.

The drum brake lines end in a 10mm pipe fitting so it can't connect to the banjo fitting on the calipers, so, yeah get the brake lines and e-brake cables.

If by EK4 bumpers you mean the ones that come with the side moldings then you are not going to be able to use your 2000 front lights, fenders, or hood because the parts are different between the 96-98s and the 99-00s.

You used to be able to do that but, they changed the laws a few months ago, so now its USDM motors only.

It mounts on the Y5/7/8 oil pump, so you would have to swap over the pump, but then you would have 2 dipstick holes.

Word, the only differences between a Y8 block and a Y7 are the oil pan and the pistons. Everything else is the same.