Search results for query: *

i recently bought a 97 civic dx and i will be swapping an ls-vtec motor into it. I have done many swaps on integras and civics, but ive never worked with a 96+ civic. can somebody tell me exactly which mounts i will need? any info will help. thanks!

i have a full final drive set up including countershaft, final drive (ring gear) and countershaft bearing. i swapped a K24 motor into an '02 civic si that is going to be turbocharged. The origional final drive setup for the civic was replaced with a setup from an '02 RSX-S. The final drive of an...

I have a VAFC 2 for sale. only used for a month. i have no use for it anymore because im selling my integra. asking $250 shipped. also a black faced autometer boost guage brand new never used. i will sell it with the VAFC2

I have a PR3 ECU for sale VTECH at 4800 RPM red line at 8200 RPM. Asking $120 shipped.

FS: 2005 rsx type s 6 speed tranny make me an offer (shipping from ny not included)

I am trying to find a RHD CRX front clip with or without motor. please inform me of a websight or some location i can find one. thanks for your help.

did anybody go on the super street tour this year?

make me an offer for these mounts. fits b series motor into 88-91 civic/crx. buyer pays for shipping from ny.

does anybody know where i can find a cable to hydro tranny conversion kit? need it for a 2000 gsr motor and tranny into a 1991 integ. please let me know. thanks

motor was in great running condition when it came out of integra. 300 or best offer. located in ny

slightly used b series swap mounts for 88-91 civic/crx-$250 obo (+ shipping) please pm me.

when i installed my head on my lsvtec motor,(95 block,99 b16 head) i blew my head gasket in about 10 minutes. when i pulled the hesd back off, i noticed that the 2 copper rings toward the back of the motor (by the #4 cylinder), were crushed. On my new gasket, I removed those 2 rings, and when i...

distributor off an 89 jdm b16a and an obd1 distributor off a 95 d16z6 $120 each shipped

I bought a dohc zc (obd0) motor from JETCO in Queens, NY. They told me 500 for a longblock with in. and ex. manifold, dizzy, wireharness, etc.. I got there and the dizzy and wireharness were not on it so i talked him down to 450. While we were there, our jeep was blocking someone in a parking...

just put an obd0 dohc zc into a 91 crx si. I tried to run it off the stock dizzy from the origional d16 si motor, and it barely idles,and you have to pump the accelerator pedal for it to acually rev up. if you give it full throttle, it will just die out. im on a hunt to find an 88-89 integ dizzy...

the stock crx distributor wont bolt up. can i possibly use an 88 to 89 integra distributor?

car takes a long time to start. when i get it started you can gradually rev the engine but if you give it full throttle, it just dies out. does anybody know what it could be? please let me know. thanks

Timing belt broke in crx and im now looking for a DOHC ZC motor with low miles. If not that, then maybe a crx si head.

other than using rear disk brakes from a 90-91 crx/civic hatch si, what rear disk setup on my 88 crx?