Search results for query: *

have a 88 hf with a b18a1 swap, the other day when i drove it when I'd come to a stop or push in the clutch the rpms would drop to about 800 rpms quick and it feels like I'm down on power, any advise would be great

93 Civic D15B7 Just finished replacing the head gasket. Trying to set the timing belt and I can't seem to get it lined up correctly. I'm at least one tooth off every time. Is there enough adjustment in the distributor to make up for one tooth, or does it need to be exact? When I jump the...

ok got an 88 crx hf b18a1 obdo, heres the problem i can start the car and it idles fine, can rev it up to 6k fine, when i put it in gear and don't give it much gas it runs ok but as soon as i give it half throttle or more it bogs so bad that i have to put the pedal to the floor to keep it...

88 crx hf b18a1, got this innovative b-series linkage yesterday, and i was wondering if they sent me the right one? my d-series (on left) the part where the shifter goes the head of it goes right and the b-series goes left, is that right? also do do i need to get a shifter from an integra the...

I got the lines bleed and i get a real good pedal but as soon as i start the car the pedal goes straight to the flood!! turn the car off and the pedal comes right back. The car has sat with the brake lines open for about two years so i knew i would have some problems, any ideas???:confused:

got an 88 hf with a b18a1 in it, well its still up on jack stands and i have noticed a leak coming from where the shift linkage connects to the trans, on the shaft where the bitch pin is. is there a seal or something in there that i can change and if so how hard is it to do? will post pics...

I was just wondering if all honda starters are the same? if i could uses an H starter on a D (etc,ect) or are they model specific. thanks

just got my 88 hf with b18a1 swap in and started the engine and without pressing the gas it rev's up to 5k, is it a vaccum thing or a sensor also no codes so far, also the radiator is not hooked up yet.

when i bought my swap it came with the axles, one axle is all messed up the other one is fine, my question is how do i tell witch one is the left or the right, or does it matter? thanks :D

i'm swapping a b18a1 into my 88 crx hf, can i use the crx clutch cable or do i need one from a da? :confused: thanx bob

does anyone know where to find a model replica honda enigines, diecast or plastic. I looked around on the net and all i could find was honda motorcycles engines. (don't know if this is the right spot to post if not mods please move.)

what's the point of aftermarket LCA's, do they actually do anything or is it bling factor? I see in pics all the time people showing them off, :shrug2:

hey guys, been searching around and i'm looking for a vacuum diagram for a b18a1 into a 88 crx hf. any help would be great, thanks

93-4dr,d15b7, newb question, how do i adjust the idle? i have been adjusting it by the throttle cable, but there has to be a better way. what should the idle be? cause when i turn on a/c the idle drops so much the feel like it's going to cut off. thanx Bob

93 4door lx, when i come to a stop i can take my foot off the brakes and they still stay locked a little, if i'm on a hill it will then roll. i have tryed bleeding the brakes,new pad and rotors. it's like they are holding vacuum or the piston on the caliper is sticking? any ideas? i thought...

93 4door lx, when i come to a stop i can take my foot off the brakes and they still stay locked a little, if i'm on a hill it will then roll. i have tryed bleeding the brakes,new pad and rotors. it's like they are holding vacuum or the piston on the caliper is sticking? any ideas? i thought...

i have a b18a1(pr4 ecu) witch is obd 0 and know u can't really tune obd 0, is there any other obd 0 ecu that maybe has a better basemap or would be a perfomance wise ecu? thanks:D

were do i look to see what year my trans is and what it is( motor b18a1)

how do u get the rear trans mount off, i can't get to the bolt on the back of the mount, any ideas people? (88 crx)

i got ground control coilovers with kyb basic shocks on my crx{88}. when i lower it down my shocks bottom out on bumps pretty bad. i don't want to lift the car back up is there something elese i can do? like shortend shocks and are adjustable shocks the same as shortend shocks, if so were can i...