Search results for query: *

Ok I just finished(sort of) slapping in a h22 in my 94 lx accord. Thing will start up, then die immediately. Then it won't start at all until I cycle the key a few times and even then it's difficult. When I get it going sometimes the thing will kill and I try to give it gas, but it acts like...

Ok some of you may be aware that I have been having problems with my clutch. I completely installed my h22 engine/tranny without checking the clutch. The damn thing was acting like the clutch was always engaged so I ripped the thing apart and found out the clutch was devistated. The disk was...

K. Swapped an h22a into an accord. I know this isn't accord forum but I heard you guys are the h22 experts. The clutch needed bleeding so i bled it, now has plenty of pressure behind the pedal and no air in the lines that i know of Here's the problem: Damn thing won't move! Put it in gear (it...

K. Swapped an h22a into an accord. I know this isn't accord forum but I heard you guys are the h22 experts. The clutch needed bleeding so i bled it, now has plenty of pressure behind the pedal and no air in the lines that i know of Here's the problem: Damn thing won't move! Put it in gear (it...

K. Swapped an h22a into an accord. The clutch needed bleeding so i bled it, now has plenty of pressure behind the pedal and no air in the lines that i know of Here's the problem: Damn thing won't move! Put it in gear (it goes in, even tried manually putting it in from under the hood) and let...

Hey guys I'm near done with swapping an h22 in my 1994 accord. I've got a favor though. All the vacuum lines and stuff on top of the manifold. I need to leave today so could someone post a picture of what it should look like. :eek: Thank you.

so I've got this sensor on the back of my transmission on my stock accord and the h22. Problem is what are the two hoses that are coupled below the h22 sensor, but not anywhere on the accord? I can put up a picture if anybody would think that would help.

Hello all. I have a question about the h22 tensioner. I have heard I will need a special tool to hold the tensioner compacted for the replacement. Will I need this tool for the h23 tensioner that will replace it, or is this just for the h22. Also does anyone know the name and/or part # of this tool?

Hey guys I need some expert help. I have a 94 lx accord that I am going to be doing an h22 swap this wednsday. Problem is that my cv joints are bad and need replacing. Now I have heard that the prelude cv joints are a better design than the accords. Should I get new accord axles or is there a...

Hey guys I need some expert help. I have a 94 lx accord that I am going to be doing an h22 swap this wednsday. Problem is that my cv joints are bad and need replacing. Now I have heard that the prelude cv joints are a better design than the accords. Should I get new accord axles or is there a...

Hello everyone, I'm new here so forgive me. I have decided to upgrade my cars engine. I am seriously planning to get an H22, but need some advice in what parts I'll need. I own a 94' accord LX type 1 Trans manual. It doesn't have a vtec so what will I need to make this happen: vtec ECU...