Search results for query: *

Proven 26.9whp on stock engine... Bisimoto F22ax header group buy in special! - CB7Tuner Forums

Aftermarket preferred but may settle for OEM cast piece.....Pm if you have anything.

I checked the voltage from my ecu to my vtec pressure sensor @ the plug that plug into it. Should have a 12volt signal coming from the ecu, to the sensor, out the sensor and back to the ecu. Thing is, when i tested the harness coming form the ECU, the voltmeter only showed 1.2 volts going to the...

From left to right , I know the one furthest left is obd0 and the center came off a 92 obd1 integra. The one all the way to right is off the car I just picked up and been trying to diagnose a idle problem. I was under the impression the car has Obd1 injectors since the old owner did awy with the...

Look legit or not.....car runs like sheet with this ECU....:confused:

Need this ASAP possible. Part number SK7-J, must have this number stamped on the mounting bracket. Auto's will not work, have one already, dont want another one. email is D15beater@yahoo.com or send PM. Seller would be shipping to NC 28025. Thanx.

I need some help with this transmission. I got it under the impression it was a ls trans, but the input shaft bearing was worn out. So I crack the case open and wasnt surprised to find the input bearing was missing quite a few of its balls, I found them at the magnet, squashed into little metal...

Need one in working order shipped to 28025 NC....I have paypal

Buyer claims i described the item wrong and it will not fit a b16 block. eBay Motors: 94-00 Integra mount bracket swap civic b16 b18 (item 300204155530 end time Mar-06-08 07:02:14 PST)

Not sure what it came from, had bracket on it for the wires that had pr3 stamped on it. Is it a b16 starter? Part number- DX4IR Denso starter....

Just looking for a few options. I know what fits but which one flows best. Ive got a b18a1 one but it came off a automatic and has a Egr valve, and looks like it has alot more clutter than the maual one does. Also why does the auto manifold have a egr valve??

YouTube - 700hp turbo hatch vs kawasaki z1000

It is my understanding that all 1.6 cranks are the same and interchangable between blocks. i am also under the impression from what ive gathered that a d17 crank/rod/piston assembly will fit in a d16y7/y8 block with little if no fabrication. I believe the a6 block has to be worked a little for...

Anyone know where to find a good one?? i want something lite weight.....

Sounds nutz huh? I swapped my car to mpfi back in september, also dropped a d16y7 into it, with a 91 si tranny and a pm6 ecu. Since then its run good, strong for what it is and banging the gears out till it hits its rev limiter at 7000.....until the other day when it banged 7500 in third on the...

Anyone here own this CRX??? Video - crx srt dragrace... Or these grs?? Video - two gsr's going at it....mooresville. july 12 1007 I just thought this was funny.....mustang gets run down Video - srt owns mustang mooresville 07-12-07

Like the title says....I need a OEM d16y8 cam gear.