Search results for query: *

  1. 9

    95 with B18A won't start?

    I have a 95 hatchback cx that just quit running on me. It is getting fuel and also getting spark? what do i check next? How do i read my error from my check engine light?
  2. 9

    High RPM

    I am in 5th gear
  3. 9

    High RPM

    I put a B18b into my 95 hatch cx and i run about 3,000 rpms at 60 mph? Is that to much RPM at that speed?
  4. 9

    95 Hatch with B18ls RPM?

    When i'm running about 65mph i'm running like 3300 rpms? Is this normal for an B18b Ls motor it has the integra tranny also. Is my timing messed up or my gearing?
  5. 9

    Ruff Idle

    I have a b18b in my hatch and i get a little bit of steering whell shake at idle. Any Suggestions? Also, what is the exact amount of oil for a b18b?
  6. 9

    OBD 1 Intake?

    So i can take the MAP sensor off of the 95 CX stock throttle body and mount it on my firewall and just run a vacuum line off of ls throttle body?
  7. 9

    MAP Sensor from Civic to Integra

    Will a 95 Civic Map Sensor and Throttle Position Sensor fit on a 95 Integra throttle body, are they even interchangeable?
  8. 9

    MAP Sensor

    Will a 95 Civic Map Sensor and Throttle Position Sensor fit on a 95 Integra throttle body are they even interchangeable?
  9. 9

    Evap Purge control solenoid valve

    Is the the EVAP purge control solenoid valve on the back of the intake manifold on a b18b ls motor? Does this have to be hooked up to run? I'm not sure how to convert a 1 wire 02 sensor to a 4 wire on a OBD 1 car, do you run the wires into the ecu or the wiring harness?
  10. 9

    OBD 1 Intake?

    I recently purchased a b18 ls motor, i was getting ready to swap it into my 1995 honda CX. I was using my stock CX harness because i was told it would work and the only thing i would have to change is the 1 wire to 4 wire O2 sensor. I went to hook everything up and i noticed on the intake it...
  11. 9

    New Install, loud noise when i hit bumps

    Yesterday i finished putting on my tokico blue shocks with hp racing adjustable sleeve coils it is lowered about 2 inches, when i hit a decent size bump it makes a somewhat of a loud "THUD" I did not cut the bump stops is that the problem? Will i damage anything at this point?
  12. 9

    Final Swap Info

    I am going to do my swap next week. I have a 1995 Honda Civic CX hatch. I am swapping a B18B Ls. I have all the motor mounts from the ls, i use the front and rear tranny mounts from the civic correct? I need to change the o2 sensor to a 4 wire? if so how do i wire this up? can i use the Civic...
  13. 9

    DC sports header

    I have a 95 hatch with an b18ls going in. I put a DC sports header on it and i don't have the pipe that will bolt up to it, can i buy one or do i need to get one from the junkyard.
  14. 9

    HP Racing Coilovers

    Has anyone heard anything good about HP Racing adjustable coils? They are sold on nopi
  15. 9

    Dropzone Suspension

    Is dropzone shocks and struts along with the coilovers a good setup, or are they junk? They would be installed on a 95 hatch
  16. 9

    Tachometer question and oil pressure guage

    I have a 95 hatch cx with a b18B, where do i tie in my tachometer wires into? What is the difference between a mechanical oil pressure guage and an electrical oil pressure guage? which one do i need?
  17. 9

    Tranny mounts for 95 hatch with ls swap

    Which mounts do i use for the tranny on the a b18b ls swap on a 95 hatch cx? can i use any of the stock mounts from my cx motor? do i need a new throttle cable?
  18. 9

    Which Cold Air Intake to Use for 95 with B18

    I am swapping a ls motor in my 95 hatch do i buy a cold air intake for the B18ls i have or for the car i have? I'm not sure if a cold air intake for a integra will fit in the engine bay the same one will for the civic.
  19. 9

    How to tell on ECU what OBD that it is.

    hmotorsonline sent me a PR4 with my B18b ls obd 1 and i wasn't sure if it would run it or not
  20. 9

    How to tell on ECU what OBD that it is.

    so a 3 plug PR4 is obd1? they don't post one as obd1 in the reference
  21. Try your Search on Google

Back
Top