intermediate shaft trouble

[97CTR]

I am almost finished swapping in my 97 ctr engine into my 97 ex. The problem I have run into is that the intermediate shaft that came with the swap just has splines on the end no bearing or anyting to mate with the axles. What do I need. Any info would be helpful.

 

[darwins_vtech]

I think that I had a similar problem with my swap. I did a JDM B16 into a 93 EX. I have a intermediate shaft on the tranny like a GSR does. So I bought both 95 integra LS or GSR Axels. Look a couple of pages back under this forum. and there should be a topic called AXELS - which ones? THat was me. IF you have that same problem get the axels it tells you to. Or PM me and I'll get back to you.

Darin

 

[phunky.buddha]

94-01 Integra LS axles should work fine for you.

AXLE not AXEL

 

[97CTR]

Thanks guys, the driveshaft shop sent me the wrong axles. But now I have got it straightened out.