PR3 pistons onto LS rods?

[RauL8604]

I have been searching and I haven't been able to find an answer. I don't know the technical name for this spot, but where the connecting rod slips into the bottom of the piston then the wrist pin goes through both; will the LS rod slip into a PR3 piston with no issues? I found that with the PCT CTR pistons you need to shave a mm off each side of the rod, I cannot find if PR3 pistons are the same way or not. Please help!

 

[egb19c]

Yes, LS and Pr3 pistons are simple press fit. No machining:

Compatible rod/piston combo's without maching..

* LS/B16/B20

* GSR/ITR/CTR

 

[vtecsir1]

I would have a professional press the pins in but thats my opinion.