FS: BNIB Darton MID Sleeve Kit Honda B18 block
- Thread starter HiloDB1
- Start date
- Replies 29
- Views 5K
We may earn a small commission from affiliate links and paid advertisements. Terms
insaneconceptz
New Member
sleeves
do you still have the sleeves for sale?
do you still have the sleeves for sale?
78civic
Junior Member
Those look like Diesel engine sleeves.. I just pulled the heads on my B18 and B20b and I don't know how in the world those would fit either block.
The thickness of the whole bore side (including stock liner) is only around .300!! and the water gap isn't much thicker.
The thread is under higher stock compression pistons for B20b I think.. there is a great pic of a block showing the top of the bores.
E
"They" may have sold you the wrong sleeves
The thickness of the whole bore side (including stock liner) is only around .300!! and the water gap isn't much thicker.
The thread is under higher stock compression pistons for B20b I think.. there is a great pic of a block showing the top of the bores.
E
"They" may have sold you the wrong sleeves
You can run 81mm bore pistons. They would need to be finished bored and honed. They can go up to 85mm
These are the correct sleeves. Do you even know how they resleeve a honda block?
Similar threads
