Recent content by 89CivicH/B

What is different between the 90-93 Accord sedan and wagon front bumper? I can't seem to find a new front bumper cover that will fit a wagon. Any help will be appreciated.

78 Trans Am

nothing done to either block or head......everything is stock except the PR3 pistons which bumps up my compression

Thats what i've checked.....they're dead on....thats why I dont get it

i see, so should i try to just maybe bump my timing a couple of degrees with my adj. cam gears?.....and which way should i go....advance or retard?

Where's the ticking coming from top or bottom end?

have a ZC head,intake, and cams setup for sale on Ebay right now if your interested. eBay Motors: Honda/Acura JDM ZC DOHC Head and Intake Setup (item 170046443930 end time Nov-11-06 14:27:49 PST)

If the timing is off, would that cause the rpms to surge?

c'mon.....someone, anyone any suggestions?

Ok, I just finished putting my B18A1 back together. The only thing changed is PR3 pistons instead of stock. Everything else is stock. I set my cam timing as I always have, with the dots parallel to each other and the top of the head. But I have to give it a little throttle to keep the engine...

See thats what my machinist said he thinks will happen....it will crack at the pin because of the heat and pressure applied to that one area. I think I'm just going to get new pistons just to be on the safe side and not have to worry with sticking used parts in my engine. Thanks so much for...

So only stocks and P30 will fit no mods needed....hmmm. I'm going to try to get these P30's to work then. Thanks

I just want to be sure if someone could answer, will the PR3 pistons fit on my LS rods without milling or any modification to the rods?