Recent content by 91crxhf

i think im gonna go with the zc trans because the engine im looking at comes with trans too. im kind of uneasy about swapping out those hubs though, sounds like a pain. found the motor at www.jdmsource.ca , anyone ever bought anything there?

Thanks for the replies! What i am running now is the d16a6 88-91 si engine and transmission and ecu with the hf harness ...... should i use the si tranny with the zc engine, the zc im looking at comes with the transmission.

So I found a JDM ZC 1.6 DOHC 88-91 Civic engine and thought this would be a nice swap for my 91 CRX HF.. Anyone know what I would need to do the swap. like motor mounts , mods or ecu? Also what engine code is this ZC, I read it is a D16A8 but not sure....Any help is very much appreciated.!!!

sounds to me like there is a short to ground, pinched or bare wire, grounding out when you engage the turn signal, probably have to refer to schematics to find out which wire the turn signal switch gets its power from and trace it to the source.......

thanks for the reply ill check them tomorrow, out of time today... on another post with the same problem someone thought it might be air in the coolant system..?? worth a try also .......

I just got my crx running after sitting for a very long time, when i fire it up it wants to idle a little high, then after warming up for a minute the idle jumps up and down between 1000 & 1500 rpm. i was thinking a vacuum leak or something ? The engine is a D16a6 if that helps any ...Any help...

:w00t:CRX IS RUNNING !!! :w00t: i cant believe it !! checked all my connections on the distributor and found the igniter wire was pushed out of the plug a little, plus the black/yellow wire by the fusebox on passenger side was cut in half :whatafucktard: ...... that was the firsrt time i crunk...

hahaha, i may give you my white crx if i cant get it running !! anyway, out of time for today... im gonna do some more troubleshooting tomorrow .... thanks for all the help you guys!! were gonna figure this out one way or another....its probably something really simple ..........

would the new dizzy matter if it was for a si or hf ? i cant remember which one i purchased it for....

no other plugs firing , i also swapped in my si ecu and still the same thing. this is driving me crazy, i know voltage is getting to the igniter but nothing after that!

no spark coming from the #1 plug , i also used a multimeter to check for voltage on the plug wire as i turned the motor over and got nothing , no voltage...

i never had his problem until i installed new plugs and wires , went to crank it afterward and this......

yes the new distributor came from oreillys

i have a 1991 crx hf with a d16a6 engine and ive been chasing this code 15 problem on and off for 3 years now ! the engine turns over but wont crank... shows code 15 after i try to crank it...so far ive installed a new main relay, new distributor, new plugs and new plug wires... im...