Recent content by arcueda

  1. A

    98ek obd2 d16z6 swap completion help

    looks like ill be troubleshooting this dizzy, seems like thats where my po355/tach/bogg issue is coming from. hope i can beat the snow
  2. A

    HELP 98 civic ex b16a2 swap

    sounds dumb but i had trouble with the dizzy side of the spark plug wires not being pushed in correctly before. worth a shot
  3. A

    98ek obd2 d16z6 swap completion help

    speedo works(bad vss sensor), boggs after around 2/3g still. no tach. p0355 im guessing its in the dizzy wiring no fan, i deleted the cruise control idk if thats effecting speedo, im assuning its not tho
  4. A

    98ek obd2 d16z6 swap completion help

    UPDATE+ motor runs, blew a fuse at somepoint during alternator instalation car idles great. tach and speedometer not working fan isnt kicking on. good fuse/relay/motor lead me to believe its the coolant temp sensor also havent solved p0355 yet
  5. A

    98ek obd2 d16z6 swap completion help

    UPDATE* after i installed the new dizzy i some how blew fuse #31 for ignition. popped in a new fuse, got the spark back i had lost. after messing with the ignition timing i got it to start up and and hold VERY WEAK at full throttle, im guessing my timing is a little off elsewhere still. i knew...
  6. A

    98ek obd2 d16z6 swap completion help

    i used wiring diagram found here:http://www.d-series.org/forums/engine-management/141265-d16z6-d16y8-obd1-2-distributer-wiring-conversion.html heat shrinked and soldered i had a friend come over and recheck everything with me and said it all looks right. only awkward thing was white wire on...
  7. A

    98ek obd2 d16z6 swap completion help

    i followed a wiring diag i found online here:D16z6 / D16y8 Obd1/2 Distributer wiring conversion - D-series.org ^solder and shrink wrapped. someone on another forum said use p28 ecu and jumper harness, but id like to keep it obd2 if possible so i dont run into any trouble down the line plus its...
  8. A

    98ek obd2 d16z6 swap completion help

    not getting spark now, i fear the worst for the ecu. white wire for cps doesnt seem to be reading right. not that anyone cares...
  9. A

    98ek obd2 d16z6 swap completion help

    new ebay dizzy....test ignition coil?
  10. A

    98ek obd2 d16z6 swap completion help

    sorry that was spaced out better on my preview^ supposed to show 3 columns reprenting 3 wires showing ground
  11. A

    98ek obd2 d16z6 swap completion help

    ok here what i came up with trying to diagnose the po355 cps sensor Crankshaft position sensor obd2 Harness d16z6 dizzy result (+)lt blue (+)blu/green (-) (-)white...
  12. A

    98ek obd2 d16z6 swap completion help

    i rewired the ecu, no difference, im gonna go through and check everything again with my brother turning the key while i diagnose.
  13. A

    98ek obd2 d16z6 swap completion help

    ok well thats what i did + the ecu jump, did i do too much? re-wire the y8 ecu the stock way? thanks for the help
  14. A

    98ek obd2 d16z6 swap completion help

    bump ^
  15. A

    98ek obd2 d16z6 swap completion help

    maybe i got my cuts wrong at the ecu? 4 wires leading into 2 at the ecu or 2 wires leading into 4 at the ecu?
See more
Back
Top