Recent content by cee-j

That sounds cool , i'll check it all out thanks guys

sounds like u got it

He told me that he riged up the switch but i will double check his work and its a p72 and it didn't even crank over

I did a swap last summer but buddy had to get an ecu, so he finally got one last week . He put it in and it wouldn't start , he jumped the starter and it ran fine no codes or nothing it was automatic, did i forget a step in my swap??

Sorry i don't understand your short form. Splice the pressure switch wire into ...what?

Take a look on the tranny and see what it says...it could be any d-series tranny.

Thats great thanks alot guys Anymore helpful tip about my swap???

thanx everybody :P

hey hey!!! I have 1991 sir and i just bought a b18c5 but where the vtec oil pressure switch is suppose to be there is none. Can i take the one off my b16a ????

How bad would it be to run a type r on obd0 ???

will the rear bracket mount of the d series fit on my b series ?????

hello everybody i have a 93 civic dx hatch auto and a 96 4 door integra also auto, the integra motor and tranny don't fit, the rear mount bracket is too long . Is there any way to make this fit with the auto tranny ???? If so what would be the mounts ??? The driver side mount is way off too...