Recent content by delslow-as-shyt

yo cocksmoker whats so gay about that engine i got it for free and i already have the d15b7 out so might as well throw it in plus the torque on that engine is less then 10 away from the h22a you probally dont have shit done to your car neway you just hangout at the local streetrace stripe and...

i have a f22b1 engine with the wire harness and the ecu what else do i need to do this swap or where is a good link to a website that would help me

ill buy it right now

just put the d series in the acura and sell to a stupid kid who has no i dea about enigine or cars.

Sorry, I know its in the wrong spot click it to fast. I would move it, but dont know how.

What do I need for the swap it is the same as the h22 swap right? Except that you do not need to wire a vtec controler? Which ecu should I get and do you have to drill a 3 inch hole in the floor board by the shifter for the cable shifter? I need a list of parts please.

the PCV (positive crankcase ventilation) is a valve that takes blowby gas and recycles through the engine to be burnt again it should be on the intake manifold between the NO.1 and NO.2 injectors

check you timing and valves because a car back fires do to an open exhaust valve at ignition in the combustion chamber.

Yeah bro, check the head gasket i think the white smoke is from the coolant mixture.

Thanks bro, so if it was bored over 1.60 it would be 1.96L?

how much is the displacment then if it is .60 over?

if an 1.8L engine is bored over .60, does it mean that the literage is now 2.4?

can i get close to 200-225HP with this engine

is the F22a1 GOOD ENGINE to swap into a 93 delsol whould it pull my car as good as a b16 and can you do any good mods on it I know its not a vtec but could you put a vtec head on it or should I buy a diff engine some input would help becasue I can get the F22A1 engine for 400 dollars.

yeah thats what i thought it should come off in a sec but the shit is not moving 500ft of torque is alot but its not doing the job you think i should just cut the axels for now and buy new ones how much does they run for ( what about taking the streering knuckle off and the forked piece that...