I have heard a few people make refrence to using resistors from radio shack instead of resist boxes. 10ohm 20watt i belive. I have had trouble finding information on how to wire them in. I am assuming they would just be in line with the injectors. Anyone know how they are wired or where i...
I have cleared the code 5 or 6 times in the process of replacing parts. My concern here is the NYS inspection laws. I don't know if i can just switch ecu's and have it pass inspection because NYS inspection computers will think it's a different car.
How do you go about getting your car inspected after you install a Used ecu. I know with the new laws you cant just swap ECUs, obd2 anyway. I heard I would have to take the new ecu to a honda dealer and they can reprogam the used ecu with my VIN so it would belong to My car. Anyone know exactly...
ok man I found a really good site to buy o2 sensors from its www.oxygensensors.com the prices are awsome. I usually buy the universal ones and use the plug from the old sensor. If you know someone with a tourch borrow it and heat the area where the sensor screws in the manifold. Then try turning...
I didn't run it. I was trying to ask if the engine not being warm could cause a fluctuation like that. It is not a fresh build although i did remove the head install a block guard then reinstalled the head with a new head gasket. I just wanted to compression test it before iwent much further...
Just did a compression test on my b20b with mixed results. cylinder 1 and 4 are both around 190 but 2 and 3 are 160ish. I did a block guard before I swaped it in, so i probably caused this problem. My question is... I was unable to run the engine to get it warm before I Tested it(fresh swap...
I have 95 sol and I am swaping in a b20. Motor is in and i have just gotten to the axles. I have a 94 vtec del sol axle for the passenger side(right side). Will this axle work or do i need one from a 94+ teg.
Ok heres my problem. I bought Avid racing b series to 92-95 civic swap mounts like 2 yrs ago on ebay(finally getting around to the swap). The auction said that it would work with any b series motor. Well the driver side mount that comes off of the engine are not even close to lining up with the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.