well this is the same as on the other forum topic but I clicked on the wrong page.
This car is crazy looking and has a motor to back it and best of all there is no ugly ass wing that does nothing. 10k under the hood and every thing else just about no cage and no lsd no large brakes otherwise...
ok I was trying to sell my si not too seriously a couple of months ago and posted here. Any way I need to sell this thing and thats sad but it needs to go soon It is for the most part done not too many people can say that well I guess after a roll cage and an lsd but thats it and maby endless 6...
so who makes a short throw with all of the polypro... bushings ? where do I get one and how much I have one its just a cheapy and when I was puttint my car back on my trailer after hin chicago it got smashed by my exhaust and melted my stock bushings
:blink:
for next time u dont need to take off the lower ball joint only the upper and the fork that is atached to the shock and the drive axle nut by the brake rotor just a short cut and easyer too
o k this is not a question I am just so shocked I have to preach OK I have jic suspension with front and rear strut tower braces oem front sway bar 26mm?
and a rear tie bar for the last three years an aftermarket rear sway bar has been on my list of necessities but just never got around to it...
have u guys ever raced a friend with tire wear. u just burn em till both of your tires are in the red then u line up at the start and go racing its kinda fun
your question was do they give GOOD power no but it doesnt mean u might get a couple of horsies at the flywheel if u have alot of whight reducton in your rotating mass all ready lightended top end and light wight fly it may help a liitle more but also if u are using amps for sterios (heaven for...
hey i know the question was about resleaving but maby u just might want to go with a block gaurd instead I have no idia what u are planning but they are really easy to install if you have your head off
its just to clean out the hoses and lines its not much money a couple of dollars its to add alittle to a full brake flluid change just a helpful hint to most of u out there change your brakefluid and u will notice a diffrence in pedal feel have fun stopping its almost more fun than...
i was told by some top road racers to bleed all of the brakefluid out then run isopropaline alcohol the stuff u get at wallgreens and then bleed that out after that put the new brake fluid in i guess if u ever over heat your fluid u should do this they just do it after every race on there swifts...
whooo buddie I consulted Todd at jun and he told me that each mark on the cam gear is 11/2 degrees and that u probably should not need to adjust eather side by more than 2 degrees adv or ret. and about the vafc it is a wise idea to tune that on a dyno along with the cams and have an experianced...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.