Recent content by littlecrxVTEC

thanks

Ok. How do I check it? Thanks

I think that's what the CRX world referrs to as the "main relay" sometimes? I believe thats the one that controls the fuel pump also come to think of it. Its right beside the hood latch release. But I can hear it click when I attempt to start the car and click again when you release the key...

:confused: Well I've got a problem with the fuel pump wiring in my 89 CRX si. I don't have a FSM so I need a wiring diagram of the fuel pump circuit. It has a brand new pump installed, and it ran fine until I let her sit for 6 weeks. Then it wasn't getting any power to the pump. I...

Who besides Distributor King manufactures New B16a OBD-0 distributors? I purchased a Distributor King dizzy about 3 years or more ago and its TOAST! That sucker cost me around $250 and thats a good bit of money to be paying all over again so soon. I'm pissed. Looking for a different brand...

yeah I get it. Thanks! I'll have to try that this weekend, the only time i have to drive for hours and waste all my time! yay! :mad: Need to get this mofo closer to me. Thanks again

Hey everyone. Sorry this is long. Got a pesky problem with my 89 CR-X Si not cranking. The story is this: It began as a hard to start cold problem. Slowly got worse. I could turn the key and it would spin just fine but wouldnt fire up. Trying to crank it cold was very hard, and even warm...

Thanks for the advice!

Well the injectors are leaking fuel onto the top of the intake manifold. Not only is this a fire hazard, it makes the car hard to start especially when the engine is cold and the fuel pressure has bled off. The cause? ...Might just be the grommets on top and bottom (in the fuel rail and...

Still need one! Formby said his buddy sold his out from under me! DoH! ANYONE? Thanks

...........the pic? Thanks -TIM

Just need the cable. Thanks tho. Could I see a pic? -TIM

Hello. Need a 90-91 Acura Integra throttle cable with good threads/locknuts on the adjustment. Not sure if the model matters, ls gs rs gsr etc... It's going into an 89 CRX with B16a swap. THANKS! -TIM

Ok, so for some reason I cannot find the correct part at the auto parts store. I need the exhaust cam oil seal plug for my B16a obd-0. It's JDM, so which USDM part do I order? Please don't say any B-series because I've looked at alot of B-series oil seals at the auto parts stores and none...

thanks!