Recent content by ls_vtec_b18a1

how did i tell if its is 5 sp or auto?

no motor or tranny sorry just body

parting out a 92 integra hit me at david@cvalink.com if u need something

well guys here the low down when i put a thermostat in the car it heats up pretty quick and i bleed the system and water and air comes out. when i run it with out the thermostat it still warms to 180 but takes a while. this happens while parked and running not driving and has did this sicne i...

my ls vtec over heats with a thermostat in it, i have tried 3 different ones and they all over heat. i got a new water pump and a new rad. even when over heating i do not get heat threw the vents and im am bleeding the bleed screw in the system. could my autometer gauge be missed up cause it...

im parting out a 2 door red integra gs model all parts must go i DO NOT have the following front and rear bumpers ecu, motor or tranny driver side fender seats i dont have these, but i have all the rest

i need a set of mounts for a 88-91 hatch so i can install my ls vtec in it. used mounts will be ok email me at david@cvalink.com thanks

please tell me u stillll have this and whats the cost of shipping to VA? im very very interested. email me at david@cvalink.com

when i tighten up the rod bolts on the rods to 23 ft pounds i cant turn the motor over with a wrench on the crank. it locks up the motor but if i back them off i can.

im puttn b16 pistons in my ls block the pistions are on ls rods with new rings and bearings but here the problem when i tighten the rod bolts ( arp on's at that ) the motors locked up i cant turn it over. im using 23 pd like the book calls for but its locked up tight and when i back them off the...

im putting b16 that are already on ls rods in my ls vtec. i bought new rings, rod bearings, and arp rod bolts. it will be a 11 to 1 compression with the b16 head. i have a vtec water pump, vtec oil pump, arp head studs, new head gasket, timing belt yea a vtec one. what i want to know is will i...

thanks for all the infor and my bad i meant gsr not grs its just one of those typing to fast errors sorry. thanks alot

i want to put grs pistons in my ls block for my ls vtec. just woundering is this a good combo. if so what will my compression be and what rod do i use the ls ones i hope. ;)

about the chipped ecu'' thats the spec's the man from dinan said just sayn what i was told. :blink:

i got a ecu that will give u 18 extra horse power if your interested.