The difference is the number of notches on the shaft for the TDC sensor to read. The amount of notches also has to do with the Camgears. They are different for Vtec and Non-Vtec So basically you need to match the Cam Gear and Distributors together. Same i belive goes for all the SIngle cam...
I have what i think are 4 DSM injectors Blue Tops b450l (450cc??) NP009 on the other side of the injector? I was told they came from a 95 talon. can anyone verify this? i will be using them with a p28 ecu so i need to add resitors.. now i read the resistance of the injectors with noe fuel...
I have just completed a ZC swap into a 88 DX CRX. I converted the harness from a DX to ZC. The car will start and run but i get a CEL Code 4. CYP Crankshaft postion sensor. Now for this engine it is the sensore mounted to the exsaust car? correct. I ran new wire from the sensor to the ECU C1 and...
I havw a D16Z6 in my 89 Civic DX hatch. Right now i'm using the old DX throttle cable i tried an integra cable but the inner line was too long. What cable should i be using. The DX is way too long overall.
Ok I have read all the hardware needed for this swap. I'm puttinf a B18B1 (ls motor) into a 98 Civic DX. I have the P75 computer from the integra also. Will i need to do any wiring or will this all plug in? :blink:
I have new Eibach Sportline Springs FOR SALE. I had them installed for one day. Then installed coilovers. They have about 20 miles on them.
$100 + Shipping
Email Randyschoener1@netzero.net
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.