Search results for query: *

I put a zc in my car recently and had problems today. I was pulling out of dairy barn, I get to 3000 rpms, go to shift to second, there was a loud pop and I couldn't put it into gear...Pulled over, put it in gear, let off the clutch and the engine died. So I ask you, is this a tranny problem? if...

I ran into problems with the zc tranny and was going to need new axles. So I just put the old tranny back on and used the reg. axles. My question is which is better, zc or si. A friend that had a zc in his crx said he used his stock tranny and axles because they were better. Just thought I would...

Just got the ZC in my car and if I try to rev past 3000 rpms it starts sputtering really bad. Could this be because of water in gas? If so I plan on fixing it sometime tomorrow. Because the gas has been in the car for some time now(over 6 months). I am pretty sure I know how to fix it if that...

Was trying to decide on a flywheel. Lightened obviously. 8.5 preferred. Was checking your opinions on what brand you think. 88 crx si dohc zc is the car.

I am looking to buy a 89 integra 5 spd ecu, a dohc zc high flow header, dohc zc cams, a lightened flywheel for dohc zc, and an intake manifold for the same zc. Post here, pm here or AIM(Sir XaaniX) or e-mail me at Hitman750@hotmail.com I leave aim connected almost all the time so you can almost...

Can I use integra axles on a dohc zc in a crx si? I am replacing the motor with a dohc zc and got a tranny with it. When I put the axles in they don't work. So I am thinking using integra axles, with an integ tranny, and a dohc zc? Would it work without problems? If so, then I plan on doing...

While putting my motor in we ran across a few problems. The wires were cut, not unhooked. The wiring harness isn't hooking up right either. I bought the engine from noyanusa as suggested either on this board, or honda-tech. Any idea why this stuff happened and isn't letting me get the swap do...

I was wondering how hard it would be to swap a b20 into a '90 si crx. What problems I would run into, estimate of how much i would cost, etc. etc. If there would be any problems with wiring and tranny hook up and what not. Thanks in advance.

I am currently working on upgrading my ZC motor in my 88 CRX. I would appreciate a list of upgrades that you guys/girls would suggest doing. I plan on getting it bore and stroked as well as port and polished. However I would appreciate a list of other modifications. I would also like to ask for...

I am going to get it done after port and polish and wheels. Just wanted to know how much you think I should get it done/what would be the highest that would help out. Thanks in advance. Engine is DOHC ZC, just so you know.

Sorry, wrong forum.

I just got a DOHC ZC swapped into my 88 crx si. I didn't get the ecu for the engine though, bringing me to my question. Which should I get? the Dohc ZC ECU, or the 88 teg ECU? From what i have heard the teg ECU is better, but just wanted to make sure before I bought anything.