Ok, I was planning on big things for my CRX but cannot finish what I started. Ok, I'll be honest, I didn't even start. All I did was buy everything. Here is what I have:
B18b imported from Japan by Engine Depot <40000 miles
ACT Stage 2 Clutch/9lb flywheel
S1 Cable Trans. - 75000 miles...
do I need to make a custom axle for the drivers side? right now i have a stock da half shaft/axle and the axle is too long... the wheel sticks out a bit and rubs... someon told me you must take a da axle and a civ si axle and build an axle so that it will be the proper length... is this right?
Up for sale is my complete set up:
1994 B18B imported from japan... I have all paperwork-less than 65000 miles!
S1 Cable Trans.
Stage 2 ACT Clutch
9lb EXACT flywheel
Hasport Motor Mounts
Hasport Shift Linkage
Uncut/Unaltered Engine harness & hoses
New Axles
1994 Integra complete wiring...
1991 civic dx. gutted. very minor rust on right side. two identical dents on both QPs, few other dings. OBD1 full wiring harness from a 1994 integra. dash/door panels are is in good shape. JDM predlude seats custom mounted. 178,000 miles.
1993 civic spindles/brakes
NO engine/trans! 750 obo...
This is a complete Turbonetics Turbo kit!
T3/T4 Turbo - Turbonetics
Manifold - Turbonetics
External Waistegate - Turbonetics
Digital boost control - Field
Turbo Timer - MSD
Downpipe & sensors - Turbonetics
Programmable Injector Drive
2-550cc injectors mount just before throttle body
Blow off...
Very clean b18a longblock for sale.
Intake/exhaust manifolds/valve cover
Distributor/plugs/wires
Flywheel
Clutch
Alternator
Water pump
Fuel rail/injectors
Uncut wiring harness
Power steering
Motor mounts
Starter
Trans mounts
70000 miles on the motor. I have paperwork. This engine was...
I have a b18c head for sale. I just took this head off my 1999 integra with 35000 miles on it. This is the cleanest used head i have ever seen!! I really don't want to sell it, but I am strapped for money and need to. My loss is your gain. 600$ Clinton NJ or West Chester PA
1990 Integra LS B18A 70,000 miles!!! This is almost a complete swap, it was running when pulled. It has a s1 trans attached. Everything is real clean. I have the bill of sale from the original owner. 600 obo for everything if you pick it up from Clinton NJ.
- Motor B18B1 USDM
- ECU
- Axle
- Shift Linkage
- Starter
- A/C
- Clutch
- Flywheel
- Intake Manifold
- Exhaust Manifold
- Fuel Rail
- Injectors
- Distributor
- Engine Harness
- Comes With All Sensors Needed
- Plug wires and Water Pump
The only thing this swap does not have is a...
Hey guys i am looking for a complete set up for my 91 civic... b18 or b16... doesn't have to be perfect considering i am going to be replacing the bottom end and clutch/flywheel. I will be turbocharging it so it would be great if the head and trans are in good condition. If you think you might...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.