Search results for query: *

Well i got it fixed, it ended up being a loose ecu pin (A4) that i clamped down for a snug fit, and no more check engine light. It feels alot nicer with VTEC. Thanks for the advice.

I don't think I did reset the ecu (I had reset just before i changed it i believe), so I'll try that. Also, the reason I think it's not the solenoid is because I took the solenoid off of his car and tried it on mine and it worked just fine. If all else fails I'll just run a completely new wire...

I just swapped a second gen b16a into my buddy's 93 hatch cx. It's throwing a code 21 (VTEC solenoid valve circuit). I've already verified continuity b/w the ecu pin D6 and body ground and b/w the VTEC solenoid harness connector and ecu pin A4. I've verified that there's no continuity b/w the...

Hey guys I just switched out that 90-93 axle for a 94+ one and, no dice. Problem's still there. Actually, now when I drive it I notice that it shakes and hops just as bad when I turn the wheel to the left, plus, it only does it when the car's in gear and the clutch isn't engaged. This makes me...

Thanks for the reply 92b. Yeah I did use a 94+ gsr axle on the driver side cuz I knew there was no way a 90-93 would work on that one cuz the intermediate shaft connection is way different. I think you're right about the 90-93 axle being my problem, I'm about to go change that out right now if...

Just swapped a b16 into my buddy's 93 cx hatch and there's some kind of suspension/axle problem. Whenever I turn the car about 45 degrees either direction (worse when turning right) the car makes a sort of clicking noise and seems to lift and drop slightly like something is out of round. It also...

I just swapped a second gen b16 into my buddy's 93 civic hatch cx. It idles fine until you rev it too high then it starts revving real high and then dropping (don't know how high and low cuz it doesn't have a tach). It sounds like a vacuum leak to me, but i can't find one. The only codes it's...

I am trying to swap a 4 wire o2 sensor (USDM) onto my 1 wire (JDM) harness setup. Anyone know if one of those four wires will tie into the one o2 wire I have and still allow my o2 sensor to function? (There are two black ones, a green one, and a white one; mine is a single black wire). Thanks in...