I just put a obd 0 b16a with a y1 tranny in my 90 dx civic. The Last time I did this swap I used GSR Axles and Intermediate shaft. This time I have what I was told the jdm Intermediate off the Sir. Every thing is hunky dorry except where the intermediate goes into the tranny, the rubber seal is...
I put a b16a in a 91 dx hatch. It is throwing a 15,ignition output signal, and will not start. I ran the two cylinder sensor wires from the dizzy to the ecu. C1 and C2. Are there any more wires from the distributer that need to be ran to the ecu. Does anyone know witch wire is the ignition...
I swaped in a jdm b16a which has an electronic speedo. I also have the jdm(8000 red line, kilometers an hour) instrument cluster. I had it in a crx that I ran into a inbankment at more than a 100. but I dont remember which wire on the cluster harness goes to the speedo. No Speedo No VTEC Please...
IF I took the axle from the single cam tranny we took out and put the right tail shaft on it would it be the right length. The old tranny is no good. I have the tail shaft from the zc axle. Thanks for the help.
I put a obd1 zc in a 92 civic hatchback. We did the swap in a day but now I can't find a passenger side axle that is long enough. The driver side we used a 94 integra and it works fine but the other side is about 3 inches too short. I had never even heard of an obd1 zc until my engine hook up...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.