I'll put it simply. I f*cked up. I blew a piston thru my old engine on my '90 Accord EX (manual trans). After close deliberation and a great deal, I bought a slighly used F22B1 V-TEC engine. The only problem is that the damned thing had the automatic pressure plate on it (i.e it was in an automatic car) I swapped out everything, hooked up my tranny, bought a new STG5 clutch, had a port job, blue printed, balanced, stroked, the WORKS, in anticipation that the work ahead of me wasn't going to be too great. Wrong! My question is.. how the hell do I get the thing to work. The harness had to be taken out of a '94 Accord. It was an automatic also. I was told that the loom was the same, but that the wire for the position sensor for the clutch was cut short and wrapped in the loom. I haven't been able to locate one on schematics, and I'm not too bold about cutting thru my harness. If there is ANYONE who can assist me, please. I have been without my beast for approx 9 months now, and to be frank I want it back, especially after putting all of my money in it, mods, engine work, etc.
Thx
7XtheKENNEY
Thx
7XtheKENNEY